Bill Simpson
Member
- Messages
- 1,756
I have a Ridgid so I'm not sure but a friend has asked me if I jknow what went wrong, He saiys that after he replaced the blades, his Delta (sorry don't know the model) planer tapers the cut. starts out fine but the amount of cut lessens as it passes through.
My first thought (as he said he put in new blades and it started) was that he installed the blades with the bevel turned the wrong direction. Is this possible? I know it can be done on my Ridgid and the other planers I have changed out.
Anybodyy got an opinion?
My first thought (as he said he put in new blades and it started) was that he installed the blades with the bevel turned the wrong direction. Is this possible? I know it can be done on my Ridgid and the other planers I have changed out.
Anybodyy got an opinion?