Mike Heidrick
Member
- Messages
- 127
- Location
- Bloomington, IL
I am hosting a shop tour tonight (one of two tours tonight for our WW club and friends). I have been cleaning up and rearranging the shop over the last month. My goal was 8' in and out for the tablesaw, jointer, planer, and bandsaw.
I am also hosting (and attending) a handcut dovetail class in the next couple weeks so I wanted to clean my back bench off and put on a new top (I am all about the sacrificial bench tops). While I was at it I moved my router table top to a kreg stand, and built a miter saw table for my Hitachi slider with eth Kreg Top Track. Here are all my results.
Feel free to post your shop tours as well if you have some to share!!
I am also hosting (and attending) a handcut dovetail class in the next couple weeks so I wanted to clean my back bench off and put on a new top (I am all about the sacrificial bench tops). While I was at it I moved my router table top to a kreg stand, and built a miter saw table for my Hitachi slider with eth Kreg Top Track. Here are all my results.
Feel free to post your shop tours as well if you have some to share!!