Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
Okay so I can make a ZCI for my saw, BUT.......that works fine when the blade is at 90 degrees to the table.
Can a person make one for say a 22.5 degree cut and then if so how do you do it.
I tried a variety of ways and gave up. Tried to use my 8 inch dado blade set to the same angle to cut a wider slot but for reasons that stumped me (i presume having to do with the anles) I could then not use my 10 inch bade in this slot. In the end gave up considered this tooooo dangerous to mess about with.
Anyways is it possible?
Thanks
Can a person make one for say a 22.5 degree cut and then if so how do you do it.
I tried a variety of ways and gave up. Tried to use my 8 inch dado blade set to the same angle to cut a wider slot but for reasons that stumped me (i presume having to do with the anles) I could then not use my 10 inch bade in this slot. In the end gave up considered this tooooo dangerous to mess about with.
Anyways is it possible?
Thanks