raised panel tutorial, Table saw

Dan Noren

Moderator
Staff member
Messages
7,984
Location
falcon heights, minnesota
raised panel cutting on ts with jig part 1

the first 2 pics are of the jig, the third is the board to be cut, the fourth is how the jig rides on the rip fence, the fifth is the board clamped in place, and the sixth is the blade raised and tilted to the desired angle. in this case, 14 degrees.
 

Attachments

  • IMG_0579.JPG
    IMG_0579.JPG
    90 KB · Views: 197
  • IMG_0578.JPG
    IMG_0578.JPG
    90 KB · Views: 186
  • IMG_0577.JPG
    IMG_0577.JPG
    89.1 KB · Views: 182
  • IMG_0576.JPG
    IMG_0576.JPG
    148.9 KB · Views: 181
  • IMG_0575.JPG
    IMG_0575.JPG
    103.3 KB · Views: 185
  • IMG_0580.JPG
    IMG_0580.JPG
    71 KB · Views: 183
raised panel cutting on ts with jig part 2

the first four pics are of the first 4 cuts, pic 5 is after returning the blade to 90 degrees (that's up and down larry :D) and lowering the blade to about a little more than 1/4" or so, and the sixth pic is of the finished panel.

i hope this helps you allen. it took longer to take the pics than to cut the panel.
 

Attachments

  • IMG_0585.JPG
    IMG_0585.JPG
    55.5 KB · Views: 160
  • IMG_0584.JPG
    IMG_0584.JPG
    90.6 KB · Views: 150
  • IMG_0583.JPG
    IMG_0583.JPG
    91.4 KB · Views: 145
  • IMG_0582.JPG
    IMG_0582.JPG
    98.3 KB · Views: 142
  • IMG_0581.JPG
    IMG_0581.JPG
    95.7 KB · Views: 147
  • IMG_0586.JPG
    IMG_0586.JPG
    90.2 KB · Views: 148
Top