Bill McQueen
Member
- Messages
- 140
- Location
- Lincoln AR
A little help please. I have these miter clamps the kind you assemble frames and draws with. ( I hope you know what I'm talking about their about 6" long, thin and have two screw clamps that make your boards square.
Problem; I keep causing a land slide because I haven't got a fixture to hang them on. Simple right. (and it probably is, but I've made two that don't work. As you know there not standardize, there all a little different.
Question have you guys or gal's got a solution you'd share with me. I'm pulling my hair out and I can't afford to do that!!
I've made hundreds of jig (not for theses) and they work fine but this is kind of thrown me a curve. If you just leave them around the shop and hunt them up when you need them, then don't reply, that what I'm tiring to get away from.
Thanks I have confidence in ya!
Bill
Problem; I keep causing a land slide because I haven't got a fixture to hang them on. Simple right. (and it probably is, but I've made two that don't work. As you know there not standardize, there all a little different.
Question have you guys or gal's got a solution you'd share with me. I'm pulling my hair out and I can't afford to do that!!
I've made hundreds of jig (not for theses) and they work fine but this is kind of thrown me a curve. If you just leave them around the shop and hunt them up when you need them, then don't reply, that what I'm tiring to get away from.
Thanks I have confidence in ya!
Bill