glenn bradley
Member
- Messages
- 11,516
- Location
- SoCal
In another post someone asked me about my original PRL and if I had considered going to the PRL 2 due to the hand cranking required on the PRL to elevate the collet for bit changing. I responded with my solution which I thought I had posted. I couldn't find it and this was a side topic to that thread.
Man, I'm starting to sound like a legal disclaimer at the end of a commercial. Anyway, this little lithium driver is now about $12 at Costco (I paid $14). The hex bit is about $4 (10mm). This raises or lowers the carriage as fast as I could want and yet does not go so fast that I might go too far at one end or the other by mistake. I have been using this thing for well over a year (maybe two) and its a breeze.
Man, I'm starting to sound like a legal disclaimer at the end of a commercial. Anyway, this little lithium driver is now about $12 at Costco (I paid $14). The hex bit is about $4 (10mm). This raises or lowers the carriage as fast as I could want and yet does not go so fast that I might go too far at one end or the other by mistake. I have been using this thing for well over a year (maybe two) and its a breeze.
Attachments
Last edited: