Frank Fusco
Member
- Messages
- 12,791
- Location
- Mountain Home, Arkansas
There is talk of the Raptor set going on right now.
I saw the link for the whole set and it has many angles.
However, I need to figure out how to set a tool rest for a ten degree angle. Other than the "eyeball" method, I would like ideas.
It is for the hollowing carbide cutters below.
I saw the link for the whole set and it has many angles.
However, I need to figure out how to set a tool rest for a ten degree angle. Other than the "eyeball" method, I would like ideas.
It is for the hollowing carbide cutters below.