Ron Roase
Member
- Messages
- 268
- Location
- Bloomington MN USA
Haveing a small shop I can not handle 4x8 sheets of plywood on my table saw. I made a frame of 1x2s and support it on three saw horses. It is screwed down with 2 screws counter sunk to each sawhorse. It makes a nice set up table when not being used for a cutting table.
I use a track set up for my cicular saw and have a vacume hose to keep the dust down.
I use setup blocks to aline the cut. It may not be as good as Festool but much more easy on the billfold. It is very acurate as long as you measure corectly.
I use a track set up for my cicular saw and have a vacume hose to keep the dust down.
I use setup blocks to aline the cut. It may not be as good as Festool but much more easy on the billfold. It is very acurate as long as you measure corectly.