Tony Falotico
Member
- Messages
- 519
- Location
- Lake City, Florida
Do any of you use rubber feet (or any other material) on your cutting boards? If so, why or why not? And, any sources for them? These seem kinda pricey to me http://www.vermontbutcherblock.com/catalog/product_info.php?cPath=41&products_id=121
Also, anybody had an end grain board warp? I made my first one out of hard maple & bubinga. Finished with Salad Bowl Finish cut 50% with mineral spirits, just like the Wood Whisperer. It was flat when I finished sanding it, warp has been within the last 72 hours. Is this normal? It has been VERY humid down here the last couple days.
As you probably guessed, the feet question is to solve the warp issue.
Thanks for any help you can give, Tony
Also, anybody had an end grain board warp? I made my first one out of hard maple & bubinga. Finished with Salad Bowl Finish cut 50% with mineral spirits, just like the Wood Whisperer. It was flat when I finished sanding it, warp has been within the last 72 hours. Is this normal? It has been VERY humid down here the last couple days.
As you probably guessed, the feet question is to solve the warp issue.
Thanks for any help you can give, Tony