Resaw Jig

Ron Roase

Member
Messages
268
Location
Bloomington MN USA
Have been wanting to get those feather boards that you can stack to get mor hight for resawing. Then I got an idea for the bandsaw from a picture I saw that some one had used on a table sae. I just modified it a bit and made all the 15 degree angles,just opposit as they would be for a tablesaw.
Resaw Jig  .JPG
It's pretty simple, the 1/8 th masonite just acts like a spring to hold the piece against the fence
Resaw assist Jig.JPG
these are a cople of boards that I resawed, one is curly maple I just sawed in half and the other is just some pine that I took about an 1/8th" sliver off. They are fairly uniform and was done with a 1/4" blade. I am sure with my 3/4
inch resaw blade it would be even better
Boards resawed.JPG
cost was just a few scraps.:D:thumb::rofl::rofl::rofl:
 
Top