Frank Pellow
Member
- Messages
- 2,332
- Location
- Toronto, Ontario, CANADA
(part 1 of 8)
The cabinets were a Christmas gift for my daughter Kathleen and family, so this was quite an embarrassment.
As usual, I will extract the material for this thread from my weekly journal.
2009, Nov 22:
This week I started a couple of Christmas projects. One of them is some cabinets for the Harris family to be used in the play room in their basement. The trickiest part are the units that have to fit into the corner. I bought a neat set of revolving shelves from Lee Valley that will do the job quite nicely. Here, I am trying everything for size using cardboard cutouts:
The photo was taken on the floor at my woodworking shed, but I also tried them in Kathleen’s basement when no one was around to observe me.
Here are the cutting diagrams for the corner cabinets:
I am making two of them, each with two rotating shelves.
The cabinets were a Christmas gift for my daughter Kathleen and family, so this was quite an embarrassment.
As usual, I will extract the material for this thread from my weekly journal.
2009, Nov 22:
This week I started a couple of Christmas projects. One of them is some cabinets for the Harris family to be used in the play room in their basement. The trickiest part are the units that have to fit into the corner. I bought a neat set of revolving shelves from Lee Valley that will do the job quite nicely. Here, I am trying everything for size using cardboard cutouts:
The photo was taken on the floor at my woodworking shed, but I also tried them in Kathleen’s basement when no one was around to observe me.
Here are the cutting diagrams for the corner cabinets:
I am making two of them, each with two rotating shelves.