Ron Roase
Member
- Messages
- 268
- Location
- Bloomington MN USA
I had bought a Incra Jig several years ago at one of the woodshows. I was so impressed at all the neet looking joints that was being made at the show. But of course when I got it home it was a much different story. But rather than let it go to wast I used it for many years as a rip fence on my TS. I was limited on the width of cut to 16 inches. At the time it was OK as I was making a lot of jewerly boxes. Then got into Cabinest and it was to small. So I bought a after market rip fence that I am well pleased with.I saw an add from Incra for a DVD So I am taking My Incra Jig out of storage and going to try again. I do better when I can see it being done rather than just reading instructionsWonder if any of you have had any experience with this piece of equiptment.