Chuck Beland
Member
- Messages
- 800
- Location
- Rhode Island
need some advice.
the bearing I bought has a diameter of 1.123"
I was drilling for the bearing on my corian adapter drilled a hole using a spade bit the speed was 250rpm & I used a 1-1/8" spade bits the 1" was to tight & the 1-1/8" was about 1/32" to loose.
1. Will med CA glue take up the looseness?
2. How about a small amount of epoxy just around the edge?
3. I'm worried about either the CA or Epoxy breaking down & losing vacuum & the turning turn into a missile.
4.if either the CA or epoxy will not work. I'm thinking of turning a recess & installing a large O-ring to help hold the bearing.
I'm making this one for a good friend & want it to be safe to use, so I can't afford to screw this one up.
here is my adapter it fits nice & snug just twist it on & it should work nicely.
Click pics for full size
the bearing I bought has a diameter of 1.123"
I was drilling for the bearing on my corian adapter drilled a hole using a spade bit the speed was 250rpm & I used a 1-1/8" spade bits the 1" was to tight & the 1-1/8" was about 1/32" to loose.
1. Will med CA glue take up the looseness?
2. How about a small amount of epoxy just around the edge?
3. I'm worried about either the CA or Epoxy breaking down & losing vacuum & the turning turn into a missile.
4.if either the CA or epoxy will not work. I'm thinking of turning a recess & installing a large O-ring to help hold the bearing.
I'm making this one for a good friend & want it to be safe to use, so I can't afford to screw this one up.
here is my adapter it fits nice & snug just twist it on & it should work nicely.
Click pics for full size
Last edited: