Bob Gibson
Member
- Messages
- 11,481
- Location
- Merrimack, New Hampshire
I have been using my table saw to make raised panels for as long as I can remember but now I would like to try making them with a router bit to get more variation in their shape.
My question is: do you prefer horizontal or vertical bits?
By just looking at them the horizontal bits look safer to use but I don't use my router table enough to really know.
Your thoughts, as usual, are appreciated.
My question is: do you prefer horizontal or vertical bits?
By just looking at them the horizontal bits look safer to use but I don't use my router table enough to really know.
Your thoughts, as usual, are appreciated.