Dan Mooney
Member
- Messages
- 1,920
- Location
- Portland, Oregon
Well I finally found a small propane camp stove, and got back after the bending project. The only problem I ran into this time was everything was going along steamingly, when I noticed that the steam stopped coming out of the vent hole. I finally figured out that there was a dip in the hose between the water pot and the steam tube and water condensed in the dip and blocked the steam, I propped up the hose and the steam ran again. Now all I have to do is wait till I can take the pieces out of the form and see if it stays bent.
Camp Stove
Houston, We have Steam!
Hose propped up to drain condesation
Form
Finished
Camp Stove
Houston, We have Steam!
Hose propped up to drain condesation
Form
Finished