- Messages
- 11,426
You change the blade in the table saw and put the blade on backwards.
I changed from my rip blade to the crosscut, put on the cross cut sled, and tried to cut a 2" piece of 8/4 hard maple, boy does it burn...
Took me a few second to figure out what was wrong...
Oh well time to knock off for the day. I did turn the blade around so it's ready in the morning.
I changed from my rip blade to the crosscut, put on the cross cut sled, and tried to cut a 2" piece of 8/4 hard maple, boy does it burn...
Took me a few second to figure out what was wrong...
Oh well time to knock off for the day. I did turn the blade around so it's ready in the morning.