Sealing black letters

Bill McQueen

Member
Messages
140
Location
Lincoln AR
I made sign (first one) using Milescraft pantogragh. It came out great. I have a problem though I didn't route it deep enough (wood is Oak) so I could have i didn't have to worry about veneer. I was worried about very thing else so much I didn't set the bit low enough. I had practiced enough and this was the real thing.

To my problem. I can't paint it black and belt sand or plane it off because of what I just mentioned letters not deep enough. So I need to color the letters black and then water proof the sign with something (it will be outside).

The question is what kind of paint should I use in the lettering (going to hand paint them) that would be compatible with a type of waterproofing coating.

Thanks Bill :huh:
 
Top