Bill Simpson
Member
- Messages
- 1,756
What tolerances? Looks like my hand planes are going to be honed a bit tonight.
Acclimating to my shop is a few pieces of 5/4 hard Maple, Waiting to become side panels for the driver's compartment of a Model T Towncar (1912) I'm at it again, seems the panels were not to specs (I didn't do it, previous builder did) so I must make new... had to get a new Micrometer to measure...
I plan to plane the thickness curviture, any better ideas?
Acclimating to my shop is a few pieces of 5/4 hard Maple, Waiting to become side panels for the driver's compartment of a Model T Towncar (1912) I'm at it again, seems the panels were not to specs (I didn't do it, previous builder did) so I must make new... had to get a new Micrometer to measure...
I plan to plane the thickness curviture, any better ideas?