- Messages
- 11,641
- Location
- Constantine, MI
I've been working on my router table and today I routed out the hole for the lift. I looked at many tutorials, including Stu's (thanks), and finally went with a modified Stu version. Only one little problem. I forgot to take the corner radius of the plate into consideration. Hence, my corners are screwed up.
Will this be an issue in the future? Will it catch stock? Clog with dust? Am I screwed and need to start over?
Will this be an issue in the future? Will it catch stock? Clog with dust? Am I screwed and need to start over?