- Messages
- 11,635
- Location
- Constantine, MI
Way long overdue - I am finally getting started on the urn for Linda, me, and some to sell. (Hopefully a lot to sell) Of course there were a few emotional hurdles, some good old fashion procrastinating, and a lot of mulling over the design. However, I think I'm past all of that now (well, at least 90% of it) and work started this evening on the jig for making the sides.
I don't remember which of you posted this link, but it was the catalyst for me. I had been dreading trying to make the G&G style finger joints on the table saw. Too many variables and too many chances for me to screw up. However, this jig takes all the guess work out of it and should yield reliable and predictable results every time.
I guess you never can have too many clamps.
The 1/2" MDF spacers
I'll let the glue set up overnight and then I'll square up the sides and end of the jig. I should be working some test pine through this tomorrow night!
I don't remember which of you posted this link, but it was the catalyst for me. I had been dreading trying to make the G&G style finger joints on the table saw. Too many variables and too many chances for me to screw up. However, this jig takes all the guess work out of it and should yield reliable and predictable results every time.
I guess you never can have too many clamps.
The 1/2" MDF spacers
I'll let the glue set up overnight and then I'll square up the sides and end of the jig. I should be working some test pine through this tomorrow night!
Last edited: