Rob Bodenschatz
Member
- Messages
- 360
- Location
- Pennsylvania
I am building some shop cabinets and I have a question about drawer slide installation. I am planning to build a base cabinet that is 4' wide, divided into two section like this:
Note the red arrow. I want to install drawer slides on either side of the 3/4" partition like in the picture. Is that going to give me any issues? Will the screws run into each other? Should I offset the slides to prevent that? Or, double up the partition?
Note the red arrow. I want to install drawer slides on either side of the 3/4" partition like in the picture. Is that going to give me any issues? Will the screws run into each other? Should I offset the slides to prevent that? Or, double up the partition?