TS Sled Support - Very Simple

glenn bradley

Member
Messages
11,516
Location
SoCal
I mentioned using the miter slot on my router table in a thread to Steve Shouthwood the other day. This is a silly little third-hand sort of a helper but I use it frequently.

I grabbed and old stain color-sample board as it happened to have a consistent topcoat on it despite being multi-colored :rolleyes:. I milled it to match the thickness of my tablesaw sleds.

If I am milling thin or long stock that tends to sag, I set the t-nuts into the t-slotted miter track on the router table and give 'em a twist.

sled support 003.jpgsled support 008.jpgsled support 009.jpg

If I am hanging off the other end, the recessed magnets hold the board still and provides a little support.

sled support 012.jpg

I know, kinda goofy but, it gets used more than I would have thought.
 
Top