John Whittaker
Member
- Messages
- 112
- Location
- Charlotte, NC
I've GOT to get a splitter installed on my table saw (Grizzly 1023 cabinet) I'm looking at the MJ from MicroJig. Since I use Zero clearance plates it seems to be a good choice but it only works on 90 degree cuts.
Any opinions on the MJ splitter or suggestions on an alternate splitter? What did you folks end up with and do you like it?
Thanks...
Any opinions on the MJ splitter or suggestions on an alternate splitter? What did you folks end up with and do you like it?
Thanks...