peter blair
Member
- Messages
- 42
- Location
- Ladner BC
I see that some of the bowl factories use steam to minimize the possibility of green turned bowls cracking. Has anyone tried this on a smaller scale? I was/am a boatbuilder and often used steam to bend wood but had not until now considered using it to prevent cracking. It would seem to me that steaming might just be easier than a lot of the other Protocols that I have tried but would sure like to garner any experience from any of you who may have already tried this method.
Pete
http://www.woodbowlsandthings.com
Pete
http://www.woodbowlsandthings.com