Rich Soby
Member
- Messages
- 1,553
- Location
- Cape Cod, Ma.
I haven't turned in a few years so I made sure to buy extra for this project.....
Anyhoo, I have to turn a couple of legs for the island in the kitchen I am building. I will be using a duplicator and a pattern. That much I'm fine with.
My question is that the top of the leg is going to be square and the turning will begin off of the flat bottom of the block. The block has to remain square so my first thought is to make a saw cut completly around the bottom of the block allowing for the diameter of the turning.
Is this the correct way to approach this or am I missing a more accurate method?
Thanks in advance!
Anyhoo, I have to turn a couple of legs for the island in the kitchen I am building. I will be using a duplicator and a pattern. That much I'm fine with.
My question is that the top of the leg is going to be square and the turning will begin off of the flat bottom of the block. The block has to remain square so my first thought is to make a saw cut completly around the bottom of the block allowing for the diameter of the turning.
Is this the correct way to approach this or am I missing a more accurate method?
Thanks in advance!