neil mackay
Member
- Messages
- 162
- Location
- sydney australia
Here a question for the hollow vessel experts and any body else I guess as well
Until recently I have nearly always turned larger vessels ie 1-14" in dia with fairly wide mouths, of which allows me good access for sanding.
But now I have embarked on smaller dias around 4-6" with much smaller openings ie 3/4-1.5" or so.
So here my question, How do you finish off the inside? In particular sanding to a smooth finish?
This has most likely been answered eslewhere. But I am curious if there has been any advancements or ideas how to get it done.
I have a few ideas that I am working on, nothing really to offer up at present
Until recently I have nearly always turned larger vessels ie 1-14" in dia with fairly wide mouths, of which allows me good access for sanding.
But now I have embarked on smaller dias around 4-6" with much smaller openings ie 3/4-1.5" or so.
So here my question, How do you finish off the inside? In particular sanding to a smooth finish?
This has most likely been answered eslewhere. But I am curious if there has been any advancements or ideas how to get it done.
I have a few ideas that I am working on, nothing really to offer up at present