Mike Olson
Member
- Messages
- 41
- Location
- Western, NY
I finished tearing down my old shed and had a bunch of nails to pickup out of the grass. after maybe 10 minutes picking nails out of the grass i said heck with that and headed to the garage.
Spent maybe 15 minutes on this. Most of that time was spent finding small enough screws. I had a wad of old hard drive magnets that I screwed to the bottom of a 2x4 that was part of the shed and attached a piece of lath that i found somewhere.
It was amazing, though it was a pain picking the nails off after but at least i didn't have to bend over anymore. I have knee and back issues...
Used my Son's little hand saw to cut the angle and chiseled it out at an angle.
Screwed all the HDD magnets to the othersize with small screws.
Sitting on the garage floor to see if the handle angle is good and i think so.
First swipe through the grass.
Spent maybe 15 minutes on this. Most of that time was spent finding small enough screws. I had a wad of old hard drive magnets that I screwed to the bottom of a 2x4 that was part of the shed and attached a piece of lath that i found somewhere.
It was amazing, though it was a pain picking the nails off after but at least i didn't have to bend over anymore. I have knee and back issues...
Used my Son's little hand saw to cut the angle and chiseled it out at an angle.
Screwed all the HDD magnets to the othersize with small screws.
Sitting on the garage floor to see if the handle angle is good and i think so.
First swipe through the grass.