- Messages
- 11,636
- Location
- Constantine, MI
I have some drawers I built for another project that could not be used (don't ask why ). I thought I might use them in a shop storage project but want to keep the case as simple as possible - just a plywood box with shelves and the drawers would fit in between the shelves. Since they were made to be inset drawers, I'm having trouble finding slides that don't require a large clearance all around, even the under mounts. So, I was thinking (always dangerous ) that I could just put a UHMW tape strip on the bottom of the drawer sides and where the sides would ride in the box.
Anybody have any luck with this type of set up?
Anybody have any luck with this type of set up?
Last edited: