Barry Gleason
Member
- Messages
- 2
bandsaw drift
I have adjusted the fence to my Grizzly 0555X to compensate for blade drift, and tried my best to tension the factory 3/8" blade properly. Still, for the first 4 inches or so of a rip cut using the fence the blade wanders in a gentle "S" pattern before settling into a cut parallel to the fence. Has anyone seen this before and found a solution to it. Feed rate seems to not matter.
I have adjusted the fence to my Grizzly 0555X to compensate for blade drift, and tried my best to tension the factory 3/8" blade properly. Still, for the first 4 inches or so of a rip cut using the fence the blade wanders in a gentle "S" pattern before settling into a cut parallel to the fence. Has anyone seen this before and found a solution to it. Feed rate seems to not matter.