Does anyone use Incra miter 5000

Messages
2,700
Location
Los Angeles, CA
Seller's price is $175 for a very good condition Incra miter 5000. New one is $262 on Amazon.

Has anyone used it. Pros and Cons?

I will primarily use it to cut small segments for woodturning.
 
I looked long and hard at the 5000, but in the end I went with the SmartMiter by jointech. I know BOTH are very nice and will do fine jobs. Here is a good discussion on the two products. If this will be your first incremental tool, you will love it. When I made the switch I was amazed how much of an improvement it made in my work. I've since switched my table saw over to an incremental setup too. Love the stuff.


http://www.sawmillcreek.org/showthread.php?46465-Incra-5000-vs.-Jointech-SmartMiter

Just my thoughts...
 
Top