Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
A turner friend of mine that I write back and forth with on all sorts of woodturning topics suggested that I try to finish the box Elder using a method he has used on similar types of wood (soft, punky, weak grain etc....) and finish it with Wipe on Poly ............which I have never tried but I do have a container of it so I thought I would give it a try.
I took the test pc of Box Elder that I had been playing with which has been sitting out drying the past 5 days and give it a try. Used my moisture meter and it said it was 5-7%..........Good Enough............LOL
I sanded to 220 - applied one good coat of Min Wax Wood Conditioner and let it dry for a couple hrs.....(Container says 1hr).... Then sanded it back with 220, then sprayed couple light coats of shellac on 30min apart (approx).............At this point he said to let it sit for 24hrs but,.... I didn't...........It sat for about 6 hrs. I then sanded it again with 220, then wet sanded with 320, 400, 500 using Mineral Spirits (not sure it that was the best medium to use but it seemed to work)......Wiped down well and applied first coat of Wipe on Poly very light and it seemed to dry very quickly and drag a bit when I was putting it on. I used a cut pc of old shirt......4hrs later knocked it down with 0000 - cleaned it off well and applied another coat - this coat went on much easier - Now sitting to dry for 24hrs.....................
After 24hrs - he said to sand with 600 and coat again - let sit for 24hrs and repeat for a total of 5 coats - let sit a week and buff with WD lightly - then hand apply Renissance and buff off..............
Observation - The Wood Conditioner did make the wood much stiffer, sanding was normal and I knocked it down well - It also works very well on Pine
Question - Never used Wipe on Poly - First coat still soaked up fast and felt like I was dragging the cloth on the surface
Second coat smoother but still see drag lines lightly on the finish............anybody doing it differently ???
I took the test pc of Box Elder that I had been playing with which has been sitting out drying the past 5 days and give it a try. Used my moisture meter and it said it was 5-7%..........Good Enough............LOL
I sanded to 220 - applied one good coat of Min Wax Wood Conditioner and let it dry for a couple hrs.....(Container says 1hr).... Then sanded it back with 220, then sprayed couple light coats of shellac on 30min apart (approx).............At this point he said to let it sit for 24hrs but,.... I didn't...........It sat for about 6 hrs. I then sanded it again with 220, then wet sanded with 320, 400, 500 using Mineral Spirits (not sure it that was the best medium to use but it seemed to work)......Wiped down well and applied first coat of Wipe on Poly very light and it seemed to dry very quickly and drag a bit when I was putting it on. I used a cut pc of old shirt......4hrs later knocked it down with 0000 - cleaned it off well and applied another coat - this coat went on much easier - Now sitting to dry for 24hrs.....................
After 24hrs - he said to sand with 600 and coat again - let sit for 24hrs and repeat for a total of 5 coats - let sit a week and buff with WD lightly - then hand apply Renissance and buff off..............
Observation - The Wood Conditioner did make the wood much stiffer, sanding was normal and I knocked it down well - It also works very well on Pine
Question - Never used Wipe on Poly - First coat still soaked up fast and felt like I was dragging the cloth on the surface
Second coat smoother but still see drag lines lightly on the finish............anybody doing it differently ???