A little desk

I started this thing about ten years ago and it's been put on hold a couple of times. I've finally gotten to a point where I can get it wrapped up. I just spent a little time planing down a few boards for the top. Actually, most of the top will be plywood but I needed to plane enough material to band the perimeter. Hope to finish that up along with the privacy panel and get this thing assembled this weekend.
 

Attachments

  • 100_2776.jpg
    100_2776.jpg
    39.7 KB · Views: 55
  • 100_2769.jpg
    100_2769.jpg
    53.9 KB · Views: 50
  • 100_2770.jpg
    100_2770.jpg
    49 KB · Views: 52
  • 100_2772.jpg
    100_2772.jpg
    29.9 KB · Views: 48
  • 100_2773.jpg
    100_2773.jpg
    49.8 KB · Views: 51
  • 100_2774.jpg
    100_2774.jpg
    44.6 KB · Views: 50
  • 100_2775.jpg
    100_2775.jpg
    39.7 KB · Views: 46
Finished up and moved in last night. I still need to add a privacy panel on the back and pick up some file hangers for the file drawers but otherwise it's ready to use.
 

Attachments

  • Desk-1.jpg
    Desk-1.jpg
    34 KB · Views: 12
  • Desk-2.jpg
    Desk-2.jpg
    60.7 KB · Views: 14
  • Desk-3.jpg
    Desk-3.jpg
    36.2 KB · Views: 13
  • Desk-4.jpg
    Desk-4.jpg
    57.5 KB · Views: 12
It is nice to have this one done but I can still beat the long drawn out project by a couple of more years. I have four cherry table legs that I turned in 1989 and then we were given a nice new dinette set so the table was never finished. I plan to use them in a drop leaf side table that i hope to build later this year.

Larry, those are attached by means of a stub tenon and mortise. kind of like this:
Sketch.jpg
 
Top