Roger Pozzi
Member
- Messages
- 75
- Location
- Mount Vernon, Ohio
I just built a small crosscut sled to aid me in box building. I used ½” phenolic faced plywood for the base with hard maple for the fence and Incra miter sliders. It’s only 12” deep since I never use lumber wider than 8” to 10” anyway.
My question to all the experts and users of crosscut sleds is: How precise should I expect to get this set up?
After 6 tries using the 5 cut method, I have 1/64” or .0145” difference in a 8” cut. Is that considered close enough?
I just want my boxes to come out square along with some small molding I use on some styles I build.
Thank you all in advance for your thoughts on this.
My question to all the experts and users of crosscut sleds is: How precise should I expect to get this set up?
After 6 tries using the 5 cut method, I have 1/64” or .0145” difference in a 8” cut. Is that considered close enough?
I just want my boxes to come out square along with some small molding I use on some styles I build.
Thank you all in advance for your thoughts on this.