George Blevins
Member
- Messages
- 68
- Location
- Baltimore, Mary land
Well lets see... This might seem like a stupid question, but I have to ask it. My wife gave me a 1.5 horse power shaper from Grizzly (anniversary gift). I purchased a set of shaper cutters from Wood Craft online. The problem that I am having is, I'm not sure which way is up on the cutters. I have never used a shaper before.
I installed the raised panel cutter and tried shaping a piece of pine, only to have burning, smoking as if it was a very dull cutter.
I'm assuming the cutter is installed up side down, but I haven't changed it yet. I was just to frustrated to deal with it! Ugg!
Thanks,
George
I installed the raised panel cutter and tried shaping a piece of pine, only to have burning, smoking as if it was a very dull cutter.
I'm assuming the cutter is installed up side down, but I haven't changed it yet. I was just to frustrated to deal with it! Ugg!
Thanks,
George