shaper

ken lutes

Member
Messages
98
Location
Winchester Ky.
SOLD I have an old craftsman shaper. This is the one with the cast iorn open table. I believe it hasa 1/2 inch spindle. This is a project. I know the motor is burnt out. The spindle seems to turn freely and it works up and down smoothly. there is a few spots of surface rust on the table but it will clean up good. with a little TLC it would make a good tool. $50.00. You may have noticed I have listed a couple of other tools for sale, there is a new project on the way and I am needing to make room in my shop. . 859 771 4304
 
Last edited:
Top