Alan Bienlein
Member
- Messages
- 2,045
Well I just used my slot mortiser to help make the Pantorouter. I needed to do some box joints for the base where you clamp your pieces and thought why not try it instead of the table saw. I clamped my resaw fence from the bandsaw to the table of the slot mortiser and clamped my pieces to it in the vertical position. I had a 1/4" router bit in it already so I used that since I already had it setup. Talk about simple! The only setup was for the depth of cut. Other than that just turn the crank the correct number of turns for the size bit you are using and get to it.
I figure I would also attach a few pictures of the Pantorouter also. Still need to make some templates but that can wait till I get ready to start a project.
I figure I would also attach a few pictures of the Pantorouter also. Still need to make some templates but that can wait till I get ready to start a project.