Matt Hutchinson
Member
- Messages
- 438
- Location
- Grand Rapids, MI
So I purchased a Porter Cable 890 series router when they were on sale at Woodcarft a while back. I finally dragged it out of storage only to find that the collet was sadly machined, and the bit changing experience was a bit bizzare (They tried to make it a one wrench system, but it is seriously lacking in ergonomics and ease of use). My intention was to install this router in a table, not using a router lift, but at this point I am not sure what to do. What router do you prefer for your router table? Do you have opinions on a router lift? Thanks!
Hutch
Hutch