Bruce Thomas
Member
- Messages
- 49
- Location
- Ararat Victoria Australia
Hi All, i have just purchased a "carbi-tec" 15 inch thicknesser ( second hand ) It seems to run very well, but after a few minutes use, the thicknesser cuts out, it doesn't seem to matter if its under load or just running in between passes. After a couple of minutes, i press the start button and off it goes again - I don't have a lot of patience at the best of times, so getting just a little annoyed as to why this is happening - so i will leave the floor open to the members, any ideas guys .. please ??