Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
Ok so I started looking around for a place to get a couple of new lasers from - Amazon has a few listed and I was wondering what the difference is in them or if anyone uses something better ?
Below are the names of the one that I have bought in the past:
RED Laser Module 8mm X 25mm - 650nm 3 Volt <1mW
Then I see these other 2 listed as well -
RED Laser Module 8mm X 25mm - 650nm 3 volt
RED Laser Module 8mm X 25mm- 635nm 5 Volt <5mW
Any thoughts on which would be better to buy ?....................or other vendors and what are others using in their Monster Hollowing rigs ????
Also wondering which measurements would matter most? is 8mm the round and 25mm the length?........I can adjust the volts on the little transformer box to 5 volt I guess ........the 650 or 635 is that the brightness ? .........wondering if there are better or cheaper lasers out there......I know Ebay has them in bulk but not sure about the brightness etc............ anybody shed some light on the specs or suggestions ??
Thanks Dan
Below are the names of the one that I have bought in the past:
RED Laser Module 8mm X 25mm - 650nm 3 Volt <1mW
Then I see these other 2 listed as well -
RED Laser Module 8mm X 25mm - 650nm 3 volt
RED Laser Module 8mm X 25mm- 635nm 5 Volt <5mW
Any thoughts on which would be better to buy ?....................or other vendors and what are others using in their Monster Hollowing rigs ????
Also wondering which measurements would matter most? is 8mm the round and 25mm the length?........I can adjust the volts on the little transformer box to 5 volt I guess ........the 650 or 635 is that the brightness ? .........wondering if there are better or cheaper lasers out there......I know Ebay has them in bulk but not sure about the brightness etc............ anybody shed some light on the specs or suggestions ??
Thanks Dan
Last edited: