How would I accomplish this?

Guy Bratt

Member
Messages
64
Location
Richmond, MI near Port Huron
What I'd like to do is turn a bowl from a board. I've done this before so I know how to line my cuts for the bowl part.
What I'm trying to do is add a wedge to the primary stock. I don't have a jointer to angle the board. My stock would be 8 to 10 inches square. I'm looking for suggestions as to how I can make the wedges flat for glue up. I've included a drawing of what I what to do. Glue red to blue.View attachment bowl_board2.skp I hope this shows up
 
I don't currently have sketchup installed on my active computer, but if you can export the picture you want us to look at as a jpg, I would be glad to try to help you.
 
Top