Jim Evatt
Member
- Messages
- 26
- Location
- Upstate S.C. near Anderson
Got a 2236 Jet lathe, and Ring Master lists one to fit it. Anybody got this setup? If so, what are your delights, discoveries, and regrets? Thanks!
Ring Master for lathe?
- Thread starter Jim Evatt
- Start date
Jim C Bradley
Member
- Messages
- 4,945
Jim,
Sorry I am no help. I don't even know what a Ring Master is. I am curious; educate me.
Enjoy,
JimB
Sorry I am no help. I don't even know what a Ring Master is. I am curious; educate me.
Enjoy,
JimB
Larry Matchett
Member
- Messages
- 8
- Location
- Gulf Coast MS
Why not just use a parting tool to do the same thing?
craig lapiana
Member
- Messages
- 13
a ringmaster only cuts rings from a board to make a bowl. it does this very well and you can make some fantastic bowls with it but nothing much. they sold a tool rest at one point but the lathe doesnt have a tail stock. typically a bowl is created after gluing a bunch of rings together and then a full size lathe is used to sand it or use the full size lathe tool rest.