larry merlau
Member
- Messages
- 18,741
- Location
- Delton, Michigan
how do you construct your drawers, specifically the backs of them and why you do it that way?
I have made them in several different ways but by far the easiest way is to make the back narrower and slide the bottom in and then pin nail or screw the bottom to the back
jay i was asking about the back to the sides.
well found some info threw the net that i thought was good to share, and the author i have met so he has my approval if that means anything
whoops will need to get a link cant post a pdf here???
here is some good info.. PDF
i am sure the rest of the book would be a good source of info as well.. this guy is a good writer in my opinion.. and friendly fella too
...i was asking about the back to the sides.
most of mine are done with sliding dt in the back. They are nice and strong and dont take much time to mill. If it is for a highend kitchen then it would be half blind dt on all for corners.