Toni Ciuraneta
Member
- Messages
- 5,629
- Location
- Catalunya
Hi Guys.
I need to mortise a slot and glue with loose tenons two pieces that are going to be glued at an angle ( see cross view sketch), and I'd like any hint about how to do it and how to clamp them so that I get a tight joint.
Mortising the slot I think I would fix the piece on my vise so that the angled surface would be horizontal checking it with a level and route it off. (Any other better system will be appreciated)
But gluing and clamping I can't think about a suitable way to exert pressure on the right direction.
Any help will be greatly appreciated
I need to mortise a slot and glue with loose tenons two pieces that are going to be glued at an angle ( see cross view sketch), and I'd like any hint about how to do it and how to clamp them so that I get a tight joint.
Mortising the slot I think I would fix the piece on my vise so that the angled surface would be horizontal checking it with a level and route it off. (Any other better system will be appreciated)
But gluing and clamping I can't think about a suitable way to exert pressure on the right direction.
Any help will be greatly appreciated