Al Launier
Member
- Messages
- 1,683
- Location
- Bedford, NH
I'm tired of having of using an old (~1952 Sears "RoebucK" table saw where I Have to setup & measure for each cut: inching & tapping the fence to get the correct distance to the blade; measure from fence to front of miter slot; measure from fence to rear of miter slot; clamping the front end of fence & then using a large C-clamp on the rear end of fence. This gets old fast.
So, I've contacted a FWW member & expect to buy his Ridgid 3650 TS in about 2 1/2 months. Can't wait! My shop is growing!
So, I've contacted a FWW member & expect to buy his Ridgid 3650 TS in about 2 1/2 months. Can't wait! My shop is growing!