- Messages
- 20,169
- Location
- Springfield, Missouri
So a while back I purchased an 2.5 CFM HF Vacuum pump for working on the AC on my old Tahoe, I've not needed it for anything else, so thinking about building a vacuum rig for veneering small panels and stabilizing blanks for gun grips and knife scales.
I found the Joe Woodworker site and am thinking about using this design.
http://www.joewoodworker.com/veneering/EVS/concept.htm
Since I'm planning to do the stabilizing, I'm thinking I should set it up to do a purge of the reservoirs after pulling in the fumes from the stabilizing tank to keep the fumes out of the pump. Just wondering if anyone else is using a pump that size and if it will be big enough.
I found the Joe Woodworker site and am thinking about using this design.
http://www.joewoodworker.com/veneering/EVS/concept.htm
Since I'm planning to do the stabilizing, I'm thinking I should set it up to do a purge of the reservoirs after pulling in the fumes from the stabilizing tank to keep the fumes out of the pump. Just wondering if anyone else is using a pump that size and if it will be big enough.