Guy Bratt
Member
- Messages
- 64
- Location
- Richmond, MI near Port Huron
Hello I've been working on a sewing cabinet. I plan to install a plastic laminate top.
For practice before I do the real top I'm using the cut offs to make a router top to fit my table saw.
I bought Wilsonart 700A spray adhesive. As I was spraying it on it seemed to pulsate. It appeared to spray steadily at that rate. I was afraid I was leaving unsprayed areas so I sprayed the surface over 3-4 times.
Has anybody used this spray? Was once acrossed enough? How do I know how much is enough if once isn't?
Thanks
Guy
For practice before I do the real top I'm using the cut offs to make a router top to fit my table saw.
I bought Wilsonart 700A spray adhesive. As I was spraying it on it seemed to pulsate. It appeared to spray steadily at that rate. I was afraid I was leaving unsprayed areas so I sprayed the surface over 3-4 times.
Has anybody used this spray? Was once acrossed enough? How do I know how much is enough if once isn't?
Thanks
Guy