glenn bradley
Member
- Messages
- 11,547
- Location
- SoCal
Contractor Tablesaw PALs and Machined Steel Pulleys
These PALs have 3/8" studs which means they fit Craftsman saws made by Emerson (model number begins with 113.xxxxx) or other 3/8" stud saws like Ridgid, etc. You could also use your own 5/16" pieces of threaded rod or a cut-off bolt for Powermatic, Delta and so forth. these studs replace your rear trunnion bolts during installation.
Retail for about $21.00. Yours for $10.00 plus shipping to wherever you are from 92557.
http://ptreeusa.com/tablesaw_products.htm#PALS
A pair of machined steel pulleys for a 5/8" shafts. These are sold as being for a Craftsman saw but, any 5/8" shaft saw/motor combination (which is most of them) that uses a 1:1 ratio will work. To increase the vibration dampening qualities, add a link belt (not included).
Retail for about $28.00. Yours for $15.00 plus shipping to wherever you are from 92557.
http://ptreeusa.com/tablesaw_products.htm#belt
These PALs have 3/8" studs which means they fit Craftsman saws made by Emerson (model number begins with 113.xxxxx) or other 3/8" stud saws like Ridgid, etc. You could also use your own 5/16" pieces of threaded rod or a cut-off bolt for Powermatic, Delta and so forth. these studs replace your rear trunnion bolts during installation.
Retail for about $21.00. Yours for $10.00 plus shipping to wherever you are from 92557.
http://ptreeusa.com/tablesaw_products.htm#PALS
A pair of machined steel pulleys for a 5/8" shafts. These are sold as being for a Craftsman saw but, any 5/8" shaft saw/motor combination (which is most of them) that uses a 1:1 ratio will work. To increase the vibration dampening qualities, add a link belt (not included).
Retail for about $28.00. Yours for $15.00 plus shipping to wherever you are from 92557.
http://ptreeusa.com/tablesaw_products.htm#belt
Last edited: