Al Launier
Member
- Messages
- 1,683
- Location
- Bedford, NH
Seems like engraving wood on hobby type projects (names, words, etc.) might be fun to do & it would add a nice personal touch to finish off a project. I'm thinking of entry-mid level application which uses a router bit, or similar, rather than a Dremel engraving tool. I can envision free-hand plunge routing, but the "wobbly lines/curves" would be something I'd like to avoid. This probably means using templates, but hopefully something that is reasonable in cost, is a manual operation, and can engrave random shapes. Has anyone on this forum used this type of tool & have recommendations on low-mid level equipment.
Last edited: