Paul Douglass
Member
- Messages
- 4,984
- Location
- S E Washington State
But I have a problem (who would have guessed). In all my years of woodworking, one of the most difficult things for me is getting a zero clearance insert perfectly level with the top of my table saw. I now use boughten ones. Use to make my own and may go back to that. I adjust the thing till I think it is just right, but if I smug the screw at the front down a little, it raises the back of the insert. If I adjust one side it changes the other side. Is there a secret I am missing? I spend more time on trying to get insert just right than any other adjustment needed.