Al Launier
Member
- Messages
- 1,683
- Location
- Bedford, NH
I have an older Craftsman Drill Press (Model 113.21371) that requires the table to be manually lifted. This gets to be awkward at times & I'm getting tired of having to do this to adjust heights. I have Googled & eBayed & checked Craglist for a rack/pinion/crank handle or old/other drill presses with these parts on it that I could strip off, that I could install on the 2 3/4" dia. column. No luck at all.
Any suggestions for a source?
Thanks!
Any suggestions for a source?
Thanks!